Some seats are not suitable for fitting child seats. The diagram on the following page shows you how to attach a child seat.

The types of child seats indicated may not be available. Before using a different child seat, check with the manufacturer that it can be fitted.

In the front seat

The laws concerning children travelling in the front passenger seat differ in every country. Consult the legislation in force and follow the indications on the diagram on the following page.

Before fitting a child seat in this seat (if authorised):

- lower the seat belt as far as possible;

- move the seat as far back as possible;

- gently tilt the seatback away from vertical (approximately 25°);

- on equipped vehicles, raise the seat base as far as possible.

In all situations, reinsert the headrest to its full extent so that it does not interfere with the child seat. FRONT HEADRESTS

After installing the child seat, when this is possible, you can move the vehicle seat forward if necessary (so as to leave enough space in the rear seats for passengers or other child seats). In case of a rear-facing child seat, do not let it touch the dashboard or move it to the furthest forward position.

Do not change other settings after installing the child seat.

Fit the child seat in a rear seat wherever possible.

Make sure the child seat or the child’s feet do not prevent the front seat from locking correctly. FRONT SEATS WITH MANUAL CONTROL or FRONT SEATS WITH ELECTRIC CONTROLS

Check that when installing the child seat in the vehicle it is not at risk of coming loose from its base.

If you have to remove the headrest, check that it is correctly stored so that it does not come loose under harsh braking or impact.

Always attach the child seat to the vehicle even if it is not in use so that it does not come loose under harsh braking or impact.

RISK OF DEATH OR SERIOUS INJURY: before fitting a rear-facing child seat to this seat, check that the air bag has been deactivated. CHILD SAFETY: deactivating, activating the front passenger air bag

In the rear side seat

A carrycot can be installed across the vehicle and will take up at least two seats.

Position the child with their feet nearest the door.

Move the front seat as far forward as possible to install a rear-facing child seat, then move back the seat in front as far as it will go, although without allowing it to come into contact with the child seat.

For the safety of a child facing forwards, move the seat in front of the child as far forward as possible, remembering to move the seatback forwards to avoid contact between the seat and the child’s legs.

In all situations, remove the rear headrests. REAR HEADRESTS If necessay, position the rear seat as far as back possible. This must be done before fitting the child seat.

Check that the forward-facing child seat is resting against the back of the vehicle seat.

Fit the child seat in a rear seat wherever possible.

A child seat with support struts must never be installed on the rear center seat.

RISK OF DEATH OR SERIOUS INJURY.

Ensure that the child seat or the child’s feet do not prevent the front seat from locking correctly. FRONT SEATS WITH MANUAL CONTROL or FRONT SEATS WITH ELECTRIC CONTROLS

Installing a booster seat (group 2 or 3)

Check the operation (rolling up) of the seat belt. SEAT BELTS

Adjust the seat belt by postioning:

- the shoulder strap on the child’s shoulder without touching the neck;

- the lap belt so that it lies flat on the thighs and against the pelvis.

If necessary, adjust the position of the vehicle seat.