warning

Always make sure that there are no obstacles present (e.g. no height constraint (presence of a roof), no contact with a pavement kerb or any other obstacle) before altering the height of the vehicle's rear axle.

Risk of damage to the vehicle.

Standard driving position

With the engine on, press button 2 on the remote control for approximately two seconds.

Button 2 flashes when the vehicle height is altered to the specified setpoint. It remains on when the requested height is reached.

Operating condition: the system automatically activates the standard driving position when the vehicle speed is above approximately 3 mph (5 km/h).

High position

The high position of the rear axle is between approximately 20 mm and 30 mm above the standard driving position (measured at the wheel).

With the engine on, press button 1 on the remote control for approximately two seconds. Button 1 flashes when changing the height to the specified setpoint. It remains on when the high position is reached.

Operating condition: button 1 is active only while the vehicle speed is below approximately 3 mph (5 km/h). Beyond this speed, the system automatically re-activates the standard driving position and button 1 becomes inactive.

warning

If the vehicle is blocked by an obstacle while it is being raised, the system shuts down after approximately 60 seconds.

This function does not guarantee that there will be no damage if the vehicle comes into contact with an obstacle.

Lowered position

The low position of the rear axle is approximately 50 mm below the standard driving position (measured at the wheel).

With the engine on, press button 3 on the remote control for approximately two seconds. Button 3 flashes when changing the height to the specified setpoint. It remains on when the low position is reached.

Operating condition: button 3 is active only while the vehicle speed is below approximately 3 mph (5 km/h). Beyond this speed, the system automatically re-activates the standard driving position and button 3 becomes inactive.

warning

If the vehicle is blocked by an obstacle while it is being lowered, the system shuts down after approximately 15 seconds.

This function does not guarantee that there will be no damage if the vehicle comes into contact with an obstacle.