Renault Scenic
Depending on the vehicle, the switch A can be used to adjust the height of the headlight beams according to the load.
With the dipped beam headlights on, press or raise switch A as many times as required to select the required position on the instrument panel. The position selected is displayed on the instrument panel for approximately 15 seconds.
Note: if the lights are on, at each engine start-up the selected position is displayed on the instrument panel for approximately 15 seconds.
tip
When driving on the left in a left-hand drive vehicle (or vice versa), you must adjust your lights temporarily for the duration of your trip.
Table of adjustment position examples
Examples of positions for adjusting the control Aaccording to the load | |
|---|---|
Driver alone or with front passenger | 0 |
All seats occupied | 1 |
Driver with passengers and luggage (or load) reaching the maximum permissible all-up weight | 2 |
Driver without passengers and luggage (or load) reaching the maximum permissible all-up weight | 3 |
The table below gives some examples. In all cases, adjust the control A according to the vehicle load so that the road can be seen and other drivers are not dazzled. | |
Temporary adjustment
This can be adjusted using the multimedia screen Vehicle settings personalisation menu.
Depending on the vehicle, the adjustment must be carried out manually.
Press or raise the switch A as many times as required to select position 0 on the instrument panel.
Open the bonnet and identify the marking B next to one of the headlights.
Using a screwdriver or similar tool, turn the screw 1 a half turn towards the ˗ mark to lower the beams.
Return to the original position once your trip is over: turn the screw 1 a half turn towards the + mark to raise the beams.