Renault Arkana

Switch A is used to adjust the height of the headlight beams according to the load.

With the dipped beam headlights lit, press or lift switch A as many times as is necessary to select the required position on the instrument panel.

Note : depending on the vehicle, at each engine start-up the position selected is displayed on the instrument panel for approximately 30 seconds and 5 seconds after each press of switch A.

Examples of position:

Thermal vehicle

0

Driver alone or with a front passenger

1

All the seats are occupied

2 or 3*

Driver with passengers and luggage (or load) reaching the maximum permissible all-up weight

4

Driver without passengers and luggage (or load) reaching the maximum permissible all-up weight

* depending on the vehicle

Hybrid vehicle

0

Driver alone or with a front passenger

1

All the seats are occupied

1 or 2

Driver with passengers and luggage (or load) reaching the maximum permissible all-up weight

2 or 3

Driver without passengers and luggage (or load) reaching the maximum permissible all-up weight

This gives some examples. In all cases, adjust control A according to the vehicle load so that the road can be seen and other drivers are not dazzled.