Renault Arkana
Useable tank capacity :
- About 11 gallons (50 litres) ;
With the vehicle unlocked, to open cover 1, press area A then release. The cover 1 opens.
Use the cap holder 2 on the flap 1 during filling to hold the cap 3 in place.
For details on filling the fuel tank, refer to the information on “Filling with fuel”.
To close it, press on the fuel filler flap by hand, as far as it will go.
warning
Filler cap : this is specific.
If you have to replace it, make sure it is identical to the original cap. Contact an approved Dealer.
Never place the cap near a source of heat or flame.
Do not wash the filler area with a high-pressure washer.
Fuel grade
Use a high-grade fuel that complies with the legislation in force in each country and which must comply with the specifications given on the label on the cover 1. Engine identification, engine specifications.
tip
After filling, check that the cap and cover are closed.
warning
Do not mix even small amounts of petrol (unleaded or E85) with diesel.
Do not use ethanol-based fuel if your vehicle is not compatible with this fuel.
Do not add additive to the fuel (additive, reagent, etc.), otherwise you could damage the engine.
If you wish to add an additive to the fuel, use a product approved by our Technical Department.
Consult an approved dealer.
It is essential to use unleaded petrol. The octane rating (RON) must comply with the information given on the label on the cover 1. Engine identification, engine specifications.
Filling with fuel
With the ignition off, insert the nozzle and insert it fully before turning it on to fill the fuel tank (risk of splashing).
Keep the nozzle in this position throughout the entire filling operation.
When the pump cuts out automatically at the end of the filling procedure, a maximum of two further filling attempts may be made, as there must be sufficient space in the fuel tank to allow for expansion.
After filling, refit the cap 3 and close the flap 1 to prevent any water or foreign bodies from entering the system.
Always make sure that the cap 3, the flap 1 and its perimeter remain clean and free of dust, mud, dirt, etc.
Special case
When the vehicle has been stopped for around three months, you must add fuel to prevent damage to the fuel pump.
To do this, with the ignition off, fill up with fuel or top up with at least approximately 2.20 gallons (10 litres) then start the engine to operate the pump and renew the fuel in the circuit.
If it is not possible to add at least 2.20 gallons (10 litres) of fuel due to the fuel level in the tank, drive the vehicle until the tank has capacity.
Petrol versions
Using leaded petrol will damage the antipollution system and may lead to a loss of warranty.
To ensure that the fuel tank is not filled with leaded petrol, the fuel tank filler neck contains a restrictor fitted with a foolproof system which only allows the nozzle for unleaded petrol to be used (at the pump).
tip
Fuel types that conform to European standards with which the engines of vehicles sold in Europe are compatible : refer to the table Engine identification, engine specifications.
tip
To fill up with fuel, the engine must be stopped (and not only on standby in case of vehicles equipped with the STOP and START function) : you must switch off the engine. Vehicle with card
Fire hazzard.
warning
Persistent fuel odour
If you notice a persistent fuel odour you should :
- stop the vehicle as soon as traffic conditions allow and switch off the ignition ;
- switch on the hazard warning lights and ask your passengers to leave the vehicle and stay clear of the traffic ;
- contact an approved Dealer.
warning
No modifications whatsoever are permitted on any part of the fuel supply system (electronic units, wiring, fuel circuit, injectors, protective covers, etc.) as this may be dangerous (unless undertaken by qualified Network personnel).