Operation

10006_B1316_028_1_image.jpeg

Depending on the vehicle, the switch A can be used to adjust the height of the headlight beams according to the load.

With the dipped beam headlights on, press or raise switch A as many times as required to select the required position on the instrument panel. The position selected is displayed on the instrument panel for approximately 15 seconds.

Note: if the lights are on, at each engine start-up the selected position is displayed on the instrument panel for approximately 15 seconds.

tip

When driving on the left in a left-hand drive vehicle (or vice versa), you must adjust your lights temporarily for the duration of your trip.

Table of adjustment position examples

Examples of positions for adjusting the control A according to the load

Driver only

0

Driver alone with a front passenger

1 or 2

All seats occupied

1 or 2

Driver with passengers and luggage (or load) reaching the maximum permissible all-up weight

2 or 3

Driver without passengers and luggage (or load) reaching the maximum permissible all-up weight

2 or 3 or 4

The table below gives some examples. In all cases, adjust the control A according to the vehicle load so that the road can be seen and other drivers are not dazzled.