Switch A is used to adjust the height of the headlight beams according to the load.

With the dipped beam headlights on, press or raise switch A as many times as required to select the required position on the instrument panel.

Note: depending on the vehicle, when the engine is started, the position selected is displayed on the instrument panel for approximately 30 seconds and for five seconds each time switch A is pressed.

Table of adjustment position examples

Examples of positions for adjusting the control A according to the load

Driver alone or with front passenger

0 or 1

All seats occupied

1 or 2

Driver with passengers and luggage (or load) reaching the maximum permissible all-up weight

2 or 3

Driver without passengers and luggage (or load) reaching the maximum permissible all-up weight

3 or 4

The table below gives some examples. In all cases, adjust the control A according to the vehicle load so that the road can be seen and other drivers are not dazzled.