warning

Do not leave the tools unsecured inside the vehicle as they may be projected during braking. After use, check that all the tools are correctly clipped into their casings, then position them correctly in their housings to reduce the risk of injury.

Trim 1

Remove it by using the hubcap tool 2 (located in the tool kit) to fit the hook into one of the openings around the edge of the wheel trim.

To refit it, align it with the valve 3.

Push the retaining hooks in fully, starting on the side of valve A, followed by B and C, finishing at the side opposite valve D.

Trim 4

Remove it using the hubcap tool 2 (located in the tool kit) by engaging the hook in the opening near the edge of the trim.

To refit, position the five trim attachments facing the five wheel attachments and press hard in the middle of the trim to clip it to the wheel.