Headlight beam adjustment

Depending on the vehicle, the switch A can be used to adjust the height of the headlight beams according to the load.
With the dipped beam headlights on, press or raise switch A as many times as required to select the required position on the instrument panel.
Note: if the lights are on, at each engine start-up the selected position is displayed on the instrument panel for approximately 15 seconds.
 
Examples of positions for adjusting the switch A according to the load
Driver alone or with front passenger
0
All seats occupied
1
Driver with passengers and luggage (or load) reaching the maximum permissible all-up weight
3
Driver without passengers and luggage (or load) reaching the maximum permissible all-up weight
4
The table below gives some examples. In all cases, adjust the control A according to the vehicle load so that the road can be seen and other drivers are not dazzled.
Tip
When driving on the left-hand side of the road in a left-hand drive vehicle (or vice versa), you must adjust your headlights for the length of your stay.