To raise the headrest

Pull the headrest upwards to the desired height. Check that it is correctly locked.

To lower the headrest

Press the button 2 and guide the headrest down to the desired height. Check that it is correctly locked.

To adjust the angle of the headrest

If fitted to the vehicle, move section A towards or away from you until it reaches the required position.

To remove the headrest

Raise the headrest to its highest position (tilt the seatback backwards if necessary). Press button 2 and lift the headrest to release it.

To refit the headrest

Check that the headrest rods are clean 1. The rod with the notch should be inserted into the slot 3 fitted with the locking button 2. Insert the headrest rods into the holes (tilt the seatback backwards if necessary). Press the button 2 and push in the headrest as far as it will go, then adjust it to the desired height. Check that each rod 1 is locked on the seatback.

warning

The headrest is an important safety component: ensure that it is in place and in the correct position. The top of your head should be in line with the top of the headrest. The distance between your head and section A should be as short as possible.