Renault Master 4
Oil level
Before operation or after an extended period of inactivity, check the hydraulic oil level in the tank 1. The oil level check is carried out with the flatbed raised and the safety stay engaged Stay. Top up if the oil level is below "MINI". It should never exceed the "MAXI" level.
It is very important to choose an oil with a nominal viscosity prescribed for the ambient working temperature. Consult an Approved Dealer or the table below to select the right oil for your needs.
Hydraulic oils | ||
|---|---|---|
Room temperature (°C) | Oil graduations | |
ISO | SAE | |
from -15 to +60 | 32 | 10w |
from -7 to +75 | 46 | 20w |
from -8 to +90 | 68 | 30w |
from -7 to +90 | 100 | 40w |
from -16 to +120 | 150 | 50w |
warning
It is absolutely forbidden to use vegetable oils or additives containing substances different to the product used. Do not mix any different products.
tip
Do not use the high pressure washer on the back of the cab. Risk of water infiltration (through air extractors).
Maintenance period
| Daily maintenance |
|---|
Always check the condition of the tipper or platform before each use. |
Check for oil leaks beneath the flatbed after storage. |
Check the oil level in the hydraulic assembly tank. |
| Scheduled maintenance |
|---|
Clean the tipper or flatbed immediately after transporting a corrosive product. |
Check the tightness of the bolts on the dropside handles. Tighten them if they start to become loose. |
Regrease the dropside fasteners and pins after each cleaning. |
Have the oil changed by an Approved Dealer every 10,000 manoeuvres or every 5 years. |
Check and adjust the oil level regularly. If the oil contains water, replace it Oil level. |
Periodically check the condition of the hose and the tightness of the hydraulic system. |
Regularly grease the hinges and the grab handles of the side dropsides. |
Wash the tipper or platform with a jet of water. Do not wash the hydraulic assembly of the tipper or platform using a high-pressure washer. |
| In the event of an impact, consult an approved dealer. |
After eight months of use, check the tightening torque of the chassis links, posts, hinges, side protection wheel fenders, anti-blocking bar and compartment according to the manufacturer's camber recommendations. For further information, please contact an approved dealer. |
Visually inspect the dropside and flatbed hinges. |
Visually check the hydraulic assembly, hose and strut for leaks. |
Check that the towbar socket and clearance lights are working properly. |
Check that the battery isolation is working properly. |