Renault Master 4
General information
The conversion carried out on this vehicle makes it possible to accommodate up to seven passengers in the rear of the vehicle, in wheelchairs, removable and fixed seats. Refer to the label 1 located on one of the rear hinged doors in order to see the possible configurations for your vehicle version.
These seats comply with all of the standards required for validation and approval.
warning
These seats do not include a warning system in the event that a seat belt is not fastened. It is the responsibility of the driver to ensure that passengers properly fasten their seat belts.
Removable seat 2
Wheel arch seat 3
It is prohibited to remove the seats located near the wheel arches.
Installation, removal of a removable seat
(depending on the vehicle)
warning
To avoid any risk of injury when handling the seats, ensure that nobody is located near the moving parts.
Also check that nothing may obstruct the moving parts and their locking mechanism (body parts, animal, gravel, cloths, toys, etc.).
Installation
Move the seat 2 to the desired position using the rollers 7. Once in position, align the seat fasteners on the rails 6 until it locks in. Turn the levers 5 on each side of the seat by slightly moving the seat forwards and backwards, until they are parallel to the rails 6.
Removal
Turn the handles 4 to the right then turn the levers 5 until they are perpendicular to the rails 6. Fold the seat base, tilt the seat backwards and move it using the rollers 7.
tip
Storage
Protect the seat from moisture and dust.
warning
Each time a seat is repositioned, ensure afterwards that it locks correctly, that the seatback is properly adjusted and that the seat belt works correctly.
Settings
To adjust the seatback position, turn the knob 8 to raise or lower the tilt level.
To rotate the seat by 90°, pull the lever 9 and turn the seat in the desired direction.
warning
We would advise you not to recline the seatbacks too far to ensure that the effectiveness of the seat belts is not reduced.
warning
For safety reasons, carry out any adjustments while the vehicle is stationary.
warning
When the vehicle is moving, seats turned 90° must not be in front of forward-facing passengers.
