Ignition-starter switch on a vehicle with key

WARNING
Never start your vehicle while freewheeling on a gradient. Risk of non-activation of power-assisted steering.
There is a risk of accidents.
WARNING
Never switch off the ignition before the vehicle has stopped completely. Once the engine has stopped, the brake servo, power-assisted steering, etc., and the passive safety devices such as the Airbags and pretensioners will no longer operate.

"Stop and apply steering lock" position (LOCK 0)

To lock: remove the key and turn the steering wheel until the steering column locks.
To unlock: turn the key and the steering wheel slightly.

"On" position (ON 2)

The ignition is switched on: Any accessories (radio etc.) can be used.

"Start" position (START 3)

If the engine fails to start at the first attempt, the key must be turned back before the starter can be activated again. Release the key as soon as the engine starts.
Note: on diesel versions, it make take several seconds between turning the key and the engine starting to allow for engine preheating.

Starting the engine

Turn the ignition key to the "ON" position 2 and hold this position until the engine preheating light goes out img_2_all_069_1.svg .
Tip
Starting the vehicle
On flat, level ground, with the vehicle unladen, you are recommended to start in second gear.

To start:

on vehicles equipped with automatic gearboxes, set the lever to P or N position.

For all vehicles:

turn the key to the "START" position 3without pressing the accelerator pedal.
Release the key as soon as the engine starts.

Stopping the engine

With the engine idling, return the key to "LOCK" position 0.