warning

To avoid all risk of injury, ensure that nobody is in the proximity of the moving parts.

When lowering/raising the flatbed, ensure that nothing interferes with the moving parts.

Fitting the locking rods for the tri-tipper

warning

Never lock the tipping flatbed on two diagonally opposite points.

Use only original pins.

Risk of damage to the flatbed and chassis.

warning

To avoid all risk of injury, ensure that nobody is in the proximity of the moving parts.

When lowering/raising the flatbed, ensure that nothing interferes with the moving parts.

Before raising or lowering the tipper, insert the rods into their housings.

Diagram of tri-directional tipper locking rods

Fitting

Tri-directional tipper tilting direction

To change the tri-directional tipper tilting direction, fit the spheres:

  • 2 and 3 to tilt to the rear A;
  • 1 and 2 to tilt to the left B;
  • 3 and 4 to tilt to the right C.

Fit the locking rod for spheres 1 and 3

To fit a rod on the corresponding yoke:

  • position the rod 5 opposite the inlet hole on the corresponding yoke 6, with the foolproofing device facing downwards;
  • insert the rod all the way in;
  • fit the pin 7;
  • release the rod and check that it is held securely by the pin 7.

Fit the locking rod for spheres 2 and 4

To fit a rod on the corresponding yoke:

  • position the rod 5 opposite the inlet hole on the corresponding yoke 8, with the foolproofing device facing downwards;
  • insert the rod all the way in;
  • fit the pin 7;
  • release the rod and check that it is held securely by the pin 7.

Tilting the flatbed

warning

Precautions to take during flatbed raising or lowering operations

When raising or lowering the flatbed, the gear lever must be in neutral and the handbrake applied.

Raise the flatbed only on flat, stable and horizontal ground.

Do not stand beneath the raised and non-supported flatbed.

warning

When the tipper lowering manoeuvre is complete, return the battery isolation lever 10 to position E (OFF).

Do not use the control unit in the flatbed movement area.

To avoid all risk of injury, ensure that nobody is in the proximity of the moving parts.

tip

An audible warning sounds continuously while the tri-directional tipper is being raised or lowered.

warning

Do not drive with the flatbed raised.

With the vehicle stationary, engine running, apply the handbrake.

Move the battery isolation lever 10 to position D (ON).

Remove the remote control 11 from its housing.

To lift the flatbed

Press button 12.

To lower the flatbed

Press button 13.