tip

Only use the recommended oil and lubricant types.

Oil level

Before operation or after an extended period of inactivity, check the hydraulic oil level in the tank 1, using the graduated gauge, and refill if necessary.

As a guideline, we recommend using ISO H46 grade biodegradable hydraulic oil, a grade equivalent to that of mineral oil in accordance with VDMA 24568. It is very important to choose an oil with a nominal viscosity prescribed for the ambient working temperature.

The oil level check is carried out with the tipper raised, according to the safety instructions with the safety stay engaged Stay.

Note: the oil reservoir level check 1 is carried out with the tipper raised to maximum height. The oil level must be slightly above the "MIN" level. If the level needs to be adjusted, consult your authorised dealer.

warning

It is absolutely forbidden to use vegetable oils or additives containing substances different to the product used. Do not mix any different products.

Maintenance period

Check that the tipper operates correctly: any parts that are out of order or damaged must always be replaced before the vehicle is used.

Depending on the vehicle, check that the audible warning works correctly. If the audible warning is out of order, do not use the tipper raising/lowering control and contact an approved dealer.

Check the condition of the oil hoses. If they are worn or broken, replace them with new, original parts.

Every six months

For the tri-tipper version, grease the hinges of the tipping cylinder located underneath the tipper using a pump provided for this purpose.

tip

Do not use the high pressure washer on the back of the cab. Risk of water infiltration (through air extractors).

Monthly maintenance table

Carry out these operations monthly.

Hydraulic system maintenance

Check the oil level in the reservoir in the maximum rear tipping position (with the strut fully extended, the oil level should be above the "MIN" mark).

If necessary, top up with mineral oil: use ISO H46 biodegradable grade oil or a grade equivalent to that of mineral oil in accordance with VDMA 24568.

Check for signs of hydraulic leakage.

Check the cleanliness of the hydraulic oil (the presence of water or impurities may impair the proper functioning of the tipper).

Mechanical maintenance

Check the condition of the sphere locking rods (tri-tipper version).

Grease the hinged strut.

Check the condition of the mountings and the frame/chassis tightening points.

Grease the hinges of the rear posts.

Check that the rear posts are properly tightened.

Check the tightening of the strut mountings and rods.

Check the rear door closure mounting.

Check the working condition of the circuit breaker.

warning

During greasing operations, the tipping platform must be secured by the safety stay and the tipper must not be loaded.