Control for locking and unlocking from the inside

This enables all the doors to be locked simultaneously.

Lock or unlock the doors by pressing switch 1.

If a door or the tailgate is open or not closed properly, the doors and tailgate lock/unlock quickly.

Locking the opening elements without the remote control

With the engine and ignition off, the sliding side doors closed and a front door open, press switch 1 for more than five seconds.

Make sure you have your key with you before you leave your vehicle.

When the door is closed, all the doors and tailgate will be locked.

Unlocking from outside the vehicle will only be possible with the key for the driver’s door.

Doors and tailgate status indicator light

When the ignition is on, the indicator light integrated in switch 1 informs you of the status of the doors and tailgate:

- indicator light on, the doors and tailgate are locked;

- indicator light off, at least one door is unlocked.

When you lock the doors, the indicator light remains lit and then goes out.

Never leave your vehicle with the key inside the vehicle.

Driver’s responsibility

If you decide to keep the doors locked when you are driving, remember that it may be more difficult for those assisting you to gain access to the passenger compartment in the event of an emergency.

Manual control

Using the key

Lock or unlock the driver’s door by inserting the key fully into lock 2, and turning the key.

For more information on the remote controls, refer to the information on the “Key, radio frequency remote control: use” in Section 1.

Locking the doors manually

Turn screw 3 with the door open (using the end of the key) and close the door. This means that the doors are then locked from the outside.

The doors may then only be opened from inside the vehicle or with the key for the front doors.

Sliding side door (fuel filler cap side)

To prevent the door striking the fuel filler nozzle, a mechanical system locks it when the fuel filler flap is open.

When the fuel tank has been filled, replace the cap in its housing and close the flap. The door can now be used.