Renault Zoe Phase 2
³ Check the status of the airbag before fitting a child seat or allowing a passenger to use the seat.
² Seat which does not allow a child seat to be fitted.
Child seat fitted using the ISOFIX mounting
ü Seat which allows an ISOFIX child seat to be fitted.
± The rear seats are fitted with an anchorage point which allows a forward-facing ISOFIX child seat with universal approval to be attached. The anchoring points are located on the passenger seatback for the front seat and on the bench seatback for the rear seats.
Using a child safety system which is not approved for this vehicle will not correctly protect the baby or child. They risk serious or even fatal injury.
RISK OF DEATH OR SERIOUS INJURY:
before fitting a rear facing child seat on the front passenger seat, check that the airbag has been deactivated CHILD SAFETY: deactivating, activating the front passenger airbag.
Fit the child seat in a rear seat wherever possible.
To install an ISOFIX seat in this seat, unbuckle the seat belt by hand before engaging the bolts.
Fitting a seat ISOFIX in the rear-left seat means the middle seat cannot be used. The central seat belt will no longer be either accessible or useable.
Check that your child is always strapped in and that the belt or safety harness used is correctly set and adjusted SEAT BELTS.
If necessary, adjust the seat position accordingly.
The table below summarises the information already shown on the diagram on the next page, to ensure the regulations in force are respected.
Type of child seat | Weight of the child | Seat size ISOFIX | Front passenger seat | Rear side seats (depending on the vehicle) | Rear centre seat (depending on the vehicle) | |
Without airbag or with airbag deactivated | With airbag activated | |||||
Carrycot fitted across the vehicle Group 0 | < 10 kg | L1, L2 [F, G] | X | X | IL (2) | X |
Rear-facing shell seat Groups 0 or 0 + | < 10 kg and < 13 kg | R1 [E] | IL (1) (3) | X | IL (4) | X |
Shell seat/rear-facing seat Groups 0+ and 1 | < 13 kg and 9 to 18 kg | R3 [C] | IL (1) (3) | X | X | X |
R2 [D] | IL (4) | |||||
Forward-facing seat Group 1 | 9 to 18 kg | F3, F2, F2X [A, B, B1], | X | IUF - IL (3) | IUF - IL (4) (5) | X |
Booster seat Groups 2 and 3 | 15 to 25 kg and 22 to 36 kg | B2 | X | IUF - IL (3) | IUF - IL (4) (5) | X |
i-Size seat | X | X | X | X | ||
X = Seat not suitable for fitting child seats.
IUF/IL = On equipped vehicles, seat which allows a child seat with “Universal/Semi-universal or vehicle-specific” approval to be fitted using the ISOFIX system; check that it can be fitted.
(2) A carrycot can be installed across the vehicle and will take up at least two seats. Position the child with his or her feet nearest the door.
(3) Raise the seat to the maximum and position it as far back as possible, tilting the seatback slightly (approximately 25°).
(4) If necessary, position the vehicle seat as far back as possible. In order to install a rear-facing child seat, move the front seat as far forward as possible, then move the front seat back as far as it will go, without allowing it to come into contact with the child seat.
(5) In all situations, remove the rear headrest of the seat on which the child seat is positioned. This must be done before fitting the child seat REAR HEADRESTS. Move the seat in front of the child forwards, move the seatback forward to avoid contact between the seat and the child’s legs.
The size of the ISOFIX child seat is indicated by a letter:
- F3, F2, F2X [A, B, B1]: for forward-facing seats in Group 1 (9 to 18 kg);
- B2: boosters in groups 2 and 3 (15 to 25 kg and 22 to 36 kg);
- R3, R2 [C, D]: rear-facing seats or shell seats in group 0+ (less than 13 kg) or group 1 (9 to 18 kg);
- R1 [E]: rear-facing shell seats in group 0 (less than 10 kg) or 0+ (less than 13 kg);
- L1, L2 [F, G]: carrycots in group 0 (less than 10 kg).