new Renault Clio
Ignition switch
"Stop steering lock applied" position LOCK 0
To lock: remove the key and turn the steering wheel until the steering column locks.
To unlock: turn the key and the steering wheel slightly.
"On" position ON 2
The ignition is switched on:
Any accessories (radio etc.) can be used.
"Start" position START 3
If the engine fails to start at the first attempt, the key must be turned back before the starter can be activated again.
Release the key as soon as the engine starts.
Starting the engine
To start:
On vehicles equipped with an automatic gearbox, set the lever to P position.
Depending on the vehicle, if a gear is engaged, in order to start the engine you must press the clutch pedal or set the gear lever to neutral. The "Neutral + START" message is displayed on the instrument panel.
Special case in very cold conditions (temperatures below -20°C): to make it easier to start the engine, switch on the ignition for several seconds before starting the engine.
warning
Never switch off the ignition before the vehicle has stopped completely. Once the engine has stopped, the brake servo, power-assisted steering, etc. and the passive safety devices such as the airbags and pretensioners will no longer operate.
Petrol version
- Activate the starter without accelerating;
- release the key as soon as the engine starts.
Stopping the engine
With the engine idling, turn the key to the "LOCK" position 0.
warning
Never start your vehicle while freewheeling on a gradient. Risk of non-activation of power-assisted steering. There is a risk of accidents.
Note: on vehicles equipped with a manual gearbox, in the event of engine stalling the "Press Clutch" message will be displayed on the instrument panel. Fully press the clutch pedal to restart the engine.
tip
During a system update via the multimedia system it will not be possible to start the vehicle. Wait for the update to be completed before starting the vehicle. For more information on system updates, please refer to the multimedia instructions.
warning
Driver's responsibility when parking or stopping the vehicle
Never leave an animal, child or adult who is not self-sufficient alone in your vehicle, even for a short time.
They may pose a risk to themselves or to others by starting the engine, activating equipment such as the electric windows or locking the doors.
Also, in hot and/or sunny weather, please remember that the temperature inside the passenger compartment increases very quickly.
RISK OF DEATH OR SERIOUS INJURY.
E-tech full hybrid version
Switching on
To switch on the ignition:
- set the gear lever to P position;
- press the brake pedal;
- turn the key to the start position 3 "START" without accelerating;
- release the key as soon as the READY message appears on the instrument panel accompanied by a beep.
The message disappears when the vehicle speed is above approximately 3 mph (5 km/h).
Stopping the system E-tech full hybrid
With the vehicle stationary, turn the key to 0 "LOCK" position.
The ignition is switched off and the READY message disappears from the instrument panel.
warning
Before carrying out any operation in the engine compartment, you must switch off the ignition.
warning
Never switch off the ignition before the vehicle has stopped completely. Once the engine has stopped, the brake servo, power-assisted steering, etc. and the passive safety devices such as the airbags and pretensioners will no longer operate.
warning
Before leaving the vehicle, check that the ignition has been switched off.
warning
Driver's responsibility when parking or stopping the vehicle
Never leave an animal, child or adult who is not self-sufficient alone in your vehicle, even for a short time.
They may pose a risk to themselves or to others by starting the engine, activating equipment such as the electric windows or locking the doors.
Also, in hot and/or sunny weather, please remember that the temperature inside the passenger compartment increases very quickly.
RISK OF DEATH OR SERIOUS INJURY.