Renault Arkana
Adjusting the seat position
To move the seat forwards or back
Move the 1 switch forwards or backwards or, depending on the vehicle, lift and hold the 4 handle to unlock the seat. Release the handle once the seat is in the correct position and ensure that the seat is locked.
To raise or lower the seat base
Move the 1 switch up or down or, depending on the vehicle, move the 5 lever as many times as necessary upwards or downwards to the desired position.
Adjusting the seatback
To tilt the seatback
Activate the 2 switch forwards or backwards, or depending on the vehicle, lift the 6 handle and tilt the seatback to the desired position.
Release the handle at the desired position and make sure that it is locked.
To adjust the seat’s lumbar position
Push left or right of the button 3 to increase or decrease the support.
warning
For safety reasons, carry out any adjustments when the vehicle is not being driven.
We would advise you not to recline the seatbacks too far to ensure that the effectiveness of the seat belts is not reduced.
Nothing should be placed on the floor (area in front of driver) as such objects may slide under the pedal during braking manoeuvres, thus obstructing its use.
Central armrest 7
(depending on the vehicle)
To adjust the position of the central armrest 7, slide it forwards or backwards.
Heated seats
(depending on the vehicle)
Vehicles fitted only with heated seats
With the ignition on :
- Pressing the switch 8 on the required seat for the first time activates the heating system on high. Both integrated switch warning lights come on ;
- pressing the switch for the second time changes the heating to low. One integrated warning light comes on ;
- pressing for the third time turns the heating off.
Operating faults
When an operating fault is detected, the warning light of the 8 switch for the seat concerned switches-off after approximately five seconds. Consult an approved dealer.