Handbrake

By releasing the accelerator, the vehicle uses regenerative braking to slow down the vehicle.

Some of this energy is converted to electricity to recharge the traction battery.

Electronic selector lever 1

Selecting reverse gear

With the vehicle stationary, move the gear lever into neutral then into reverse.

Observing the grid on the lever knob 1, lift the ring 2 towards the knob in order to engage reverse gear.

This system enables a reduced fuel consumption and lower greenhouse gas emissions.

The system is activated automatically when the vehicle is started.

While driving, the system stops the engine (standby) when the vehicle is at a standstill (traffic jam, traffic lights, etc).

(Combustion version)

Up to 1,500 km, do not exceed 2,500 rpm or approximately 56 mph (90 km/h) on the highest gear. After completing this mileage you may drive faster, however, it is only after approximately 3,720 miles (6,000 km) that you may reasonably expect full performance.

During the running in period, do not accelerate hard while the engine is still cold and do not let the engine over-rev.

Service intervals: refer to the Maintenance Document for the vehicle.