Electronic parking brake

<?xml version="1.0" standalone="yes"?>

Assisted operation

Applying the electronic parking brake

With the vehicle stationary, the electronic parking brake can be used to immobilise the vehicle:

Chapter

Gearstick

<?xml version="1.0" standalone="yes"?>

Selecting reverse gear

With the vehicle stationary, move the gear lever into neutral then into reverse.

Observing the grid on the lever knob 1, lift the ring 2 towards the knob in order to engage reverse gear.

Chapter

Stop and Start function

<?xml version="1.0" standalone="yes"?>

This system enables a reduced fuel consumption and lower greenhouse gas emissions.

The system is activated automatically when the vehicle is started.

While driving, the system stops the engine (standby) when the vehicle is at a standstill (traffic jam, traffic lights, etc).

tip

The rear-wheel drive versions are not equipped with the "Stop and Start" function.

Chapter

Ignition-starter switch on a vehicle with card

<?xml version="1.0" standalone="yes"?>
tip

Starting the vehicle

On flat, level ground, with the vehicle unladen, you are recommended to start in second gear.

warning

Never start your vehicle while freewheeling on a gradient. Risk of non-activation of power-assisted steering.

There is a risk of accidents.

Chapter

Ignition switch

<?xml version="1.0" standalone="yes"?>

"Stop and steering lock" position St

To lock: remove the key and turn the steering wheel until the steering column locks.

To unlock: turn the key and the steering wheel slightly.

Chapter