| user manual

Stop and Start function

<?xml version="1.0" standalone="yes"?>

This system enables a reduced fuel consumption and lower greenhouse gas emissions.

The system is activated automatically when the vehicle is started.

While driving, the system stops the engine (standby) when the vehicle is at a standstill (traffic jam, traffic lights, etc).

tip

The rear-wheel drive versions are not equipped with the "Stop and Start" function.

Chapter

Ignition-starter switch on a vehicle with card

<?xml version="1.0" standalone="yes"?>

tip

Starting the vehicle

On flat, level ground, with the vehicle unladen, you are recommended to start in second gear.

warning

Never start your vehicle while freewheeling on a gradient. Risk of non-activation of power-assisted steering.

There is a risk of accidents.

Chapter

"Stop and steering lock" position St

To lock: remove the key and turn the steering wheel until the steering column locks.

To unlock: turn the key and the steering wheel slightly.

Chapter

Starting the engine

Chapter

Running in

<?xml version="1.0" standalone="yes"?>

(Combustion version)

Up to 1,500 km, do not exceed 2,500 rpm or approximately 56 mph (90 km/h) on the highest gear. After completing this mileage you may drive faster, however, it is only after approximately 3,720 miles (6,000 km) that you may reasonably expect full performance.

During the running in period, do not accelerate hard while the engine is still cold and do not let the engine over-rev.

Service intervals: refer to the Maintenance Document for the vehicle.

Chapter