Renault Scenic
Attachment using the ISOFIX system
Fitting diagram
Tip
For the front passenger seat, the use of a child seat with a floor support is recommended
to avoid triggering the seat belt warning signal.
WARNING
Using a child safety system which is not approved for this vehicle will not properly
protect the baby or child. They risk serious or even fatal injury.
WARNING
Fitting a seat ISOFIX in the rear-left seat means the middle seat cannot be used. The central seat belt
will no longer be either accessible or useable.
WARNING
-
- Seat which does not allow a child seat to be fitted.
Child seat attached using theISOFIX system
-
- Seat equipped for attaching a ISOFIX or i-Size child seat.
WARNING
Check that your child is always strapped in and that the belt or safety harness used
is correctly set and adjusted.
If necessary, adjust the seat position accordingly.
WARNING
Do not fit a child seat while the central seatback is folded down.
WARNING
Fit the child seat in a rear seat wherever possible.
To install an ISOFIX seat in this seat, unbuckle the seat belt by hand before engaging the bolts.
Installation table
The table below summarises the information already shown on the diagram on the previous
page, to ensure the regulations in force are respected.
Type of child seat | Weight of the child | Size of seat [fixture] | Front passenger seat (7) | Rear side seats (7) | Rear centre seat (7) | |
With airbag deactivated | With airbag activated | |||||
Carrycot fitted across the vehicle Group 0 | < 10 kg | L1 [F] L2 [G] | X | X | IL (2) | X |
Rear-facing shell seat Groups 0 or 0 + | < 13 kg | R1 [E] | IL (1) (3) | X | IL (4) | X |
Rear-facing seat Groups 0+ and 1 | < to 13 kg and 9 to 18 kg | R3 [C] R2 [D] | IL (1) (3) | X | IL (4) | X |
Forward-facing seat Group 1 | 9 to 18 kg | F3 [A] F2 [B] F2X [B1] | X | IUF - IL (3) | IUF - IL (5) | X |
Booster seat Groups 2 and 3 | 15 to 25 kg and 22 to 36 kg | B2 | X | IUF - IL (3) | IUF - IL (5) | X |
Seati-Size | Rear-facing seat | i - U (1) (3) | X | i - U (4) | X | |
Forward-facing seat | X | i - UF (3) | i - U (5) | X | ||
Booster seat | X | i - UF (6) | i - U (5) | X | ||
X = Seat not suitable for fitting child seats.
IUF = Seat allowing a child seat with "Universal or vehicle-specific" approval to be
attached using the ISOFIX system on equipped vehicles: check that it can be fitted.
IL = Seat allowing a child seat with "Semi-universal or vehicle-specific" approval to
be attached using the ISOFIX system on equipped vehicles: check that it can be fitted.
i-U = Suitable for "Universal" front-facing and rear-facing i-Size restraint devices.
i-UF = Suitable only for "universal" front-facing and rear-facing i-Size restraint devices.
WARNING
(2) A carrycot can be fitted across the vehicle and it will take up at least two seats.
Position the child with his or her feet nearest the door.
(3) Move the vehicle seat backwards as far as possible and lower it as much as possible,
then tilt the seatback slightly (by approximately 25°).
(4) Before installing a rear-facing child seat, move the front seat forwards as far as
possible then, once the child seat is installed, move the front seat backwards as
far as possible without it touching the child seat.
(5) In all situations, remove the headrest of the rear seat on which the child seat is
positioned. This must be done before fitting the child seat. Move the seat in front
of the child forwards, move the seatback forward to avoid contact between the seat
and the child's legs.
(6)Raise the seat to the maximum and position it as far back as possible, tilting the
seatback slightly (approximately 25°).
The size of the ISOFIX child seat is indicated by a letter:
- F3, F2, F2X[A, B, B1]: for forward-facing child seats in Group 1 (9 to 18 kg);
- B2: boosters in groups 2 and 3 (15 to 25 kg and 22 to 36 kg);
- R3, R2[C, D]: rear-facing seats or shell seats in group 0+ (less than 13 kg) or group 1 (9 to 18 kg);
- R1[E]: rear-facing shell seats in group 0 (less than 10 kg) or 0+ (less than 13 kg);
- L1,L2[F,G]: carrycots in group 0 (less than 10 kg).
WARNING
(7) Deactivate the "Easy Access Seat" function before installing a child seat on the
front passenger seat and/or on the rear seats FRONT SEATS: FUNCTIONS.
Risk of injury.