Position for use

Raise the headrest all the way up until it locks. Check that the bonnet is correctly locked.

To remove the headrest

Raise the headrest as far as it will go, then press button 1 and remove the headrest.

To refit the headrest

Insert the rods into their housings and lower the headrest until it locks to use it in the high position.

Check that the bonnet is correctly locked.

Headrest 2 stored position

Press the button 1 and lower the headrest completely.

The fully lowered headrest position (position2) should only be used to store the headrest when not in use: it must not be in this position while the seat is occupied.

warning

The headrest is a safety device. Make sure that it is installed correctly and in the right position.