Control A is used to correct the height of the headlights according to the load.

With the dipped-beam headlights on, press or raise the switch A as many times as necessary to select the position requested on the instrument panel.

The selected position will be displayed on the instrument panel for about 30 seconds.

Note: depending on the vehicle, whenever the ignition is switched on, the selected position is displayed on the instrument panel for approximately 30 seconds and for approximately five seconds each time switch A is pressed.

Table of Adjustment Position Examples

Examples of control A adjustment positions according to load

Driver alone or with front passenger

0

Driver with one front passenger and three rear passengers

1

Driver with one passenger in the front, three passengers in the back and luggage (or cargo) reaching the maximum total weight allowed

2

Only driver with luggage (or cargo) reaching the maximum authorised cargo weight

3

The table below gives some examples. Always adjust control A according to the vehicle load so that the road can be seen and other drivers are not dazzled.