Renault Kwid

There are two systems for fitting child seats: the seat belt or the ISOFIX system.

Attachment by seat belt

The seat belt must be adjusted to ensure that it is effective in the event of harsh braking or impact.

Ensure that the strap paths indicated by the child seat manufacturer are observed.

Always check that the seat belt is correctly fastened by pulling it up firmly, then pulling it out fully whilst pressing the child seat against the seatback.

Check that the seat is securely positioned by moving it side to side and front to back: the seat must remain securely fixed.

Check that the child seat has not been installed at an angle and that it is not resting against a window.

warning

Do not use a child seat that can release the seat belt that secures it: the seat base must not press on the seat belt buckle and/or catch.

warning

The seat belt must never have the tension relieved or be twisted. Never pass the shoulder strap under the arm or behind the back.

Check that the seat belt has not been damaged by sharp edges.

If the seat belt does not operate normally, it will not protect the child. Consult an Approved Dealer. Do not use this seat until the seat belt has been repaired.

warning

Check that the seatback of the forward-facing child seat is in contact with the seatback of the vehicle seat. In this case, the child seat may not always rest on the seat base of the vehicle seat.

Attachment using the ISOFIX system

Authorised ISOFIX child seats are approved in accordance with regulation ECE-R44 in any of the three following cases:

  • universal ISOFIX 3-point forward-facing seat;
  • semi-universal ISOFIX 2-point seat;
  • specific.

For the latter two, check that your child seat can be installed by consulting the list of compatible vehicles.

Attach the child seat with the ISOFIX locks, if these are provided. The ISOFIX system allows quick, easy and safe fitting.

The ISOFIX system consists of two rings and, in some cases, a third ring.

warning

Before using an ISOFIX child seat that you purchased for another vehicle, check that its installation is authorised. A list of vehicles which can be fitted with the seat can be provided by the equipment manufacturer.

The rings 1 are located between the seatback and the seat and they can be identified by a mark.

The third ring 3 is used to attach the upper strap of some child seats.

warning

The ISOFIX fittings have been exclusively designed to be used with child seats equipped with the ISOFIX system. Never fit a different type of child seat, seat belt or other objects to these anchorage points.

Check that nothing is obstructing the anchorage points.

If your vehicle has been involved in a road accident, have the ISOFIX fittings checked and replace your child seat.

Pass the belt 2 between the seatback and the rear parcel shelf. To do so, first remove the luggage compartment cover. Attach the hook to one of the rings 3 identified by the 1_ALL_289_1_pictogramme.png symbol.

Pull the belt 2 so that the back of the child seat comes into contact with the vehicle seatback.

warning

No modifications must be made to the originally fitted system: seat belts, ISOFIX, seats and their mountings.

warning

The child seat strap must be attached to the corresponding ring. Do not use any other mounting point.