Renault Kwid
Installation diagram
-
Seat not suitable for fitting child seats.
warning
Using a child safety system which is not approved for this vehicle will not correctly protect the baby or child. There is a risk of serious or even fatal injury.
Child seat attached using the ISOFIX system
-
Seat which allows a child seat to be attached using the ISOFIX system.
-
The rear seats are fitted with an anchorage point which allows a forward-facing ISOFIX child seat with "Universal" approval to be attached. The anchorage points are located on the backs of the rear seats.
The size of the ISOFIX child seat is indicated by a letter:
- A, B and B1: for forward-facing seats in group 1 (9 to 18 kg);
- C and D: shell-shaped seat (infant carrier) or rear-facing seats in group 0+ (less than 13 kg) or group 1 (9 to 18 kg);
- E: rear-facing seats in group 0 (less than 10 kg) or group 0+ (less than 13 kg);
- F and G: carrycots in group 0 (up to 10 kg).
warning
Ensure that children remain secured and that the child seat or seat belt is properly set and adjusted Seat belts.
If necessary, adjust the seat position accordingly.
Attachment using the ISOFIX system
Installation table
The table below summarises the information already shown on the diagram on the next page, to ensure the regulations in force are respected.
Type of child seat | Weight of the child | Seat sizeISOFIX | Front passenger seat | Rear side seats | Rear centre seat |
Carrycot fitted across the vehicle Group 0 | < 10 kg | F, G | X | X | X |
Rear-facing seat Group 0 or 0+ | < 10 kg and < 13 kg | E | X | IL (1) | X |
Rear-facing seat Group 0+ and 1 | < to 13 kg and 9 to 18 kg | C, D | X | IL (1) | X |
Forward-facing seat Group 1 | 9 to 18 kg | A, B, B1 | X | IUF - IL (2) | X |
Booster cushions Groups 2 and 3 | 15 to 25 kg and 22 to 36 kg | X | IUF - IL (2) | X |
X= Seat not suitable for installing an ISOFIX child seat.
IUF/IL = On equipped vehicles, seat which allows a child seat with "Universal/semi-universal or vehicle-specific approval" to be fitted using the ISOFIX system: check that it can be fitted.
(1) If necessary, push the car seat back as far as it will go. Move the front seat as far forward as possible to install a rear-facing child seat, then move back the seat in front as far as it will go, although without allowing it to come into contact with the child seat.
(2) In all situations, remove the rear headrest of the seat on which the child seat is fitted. This must be done before fitting the child seat. Move the seat in front of the child forwards, move the seatback forward to avoid contact between the seat and the child's legs.