Renault Kwid

Windscreen wiper/washer

Windscreen wiper

With the ignition on, move the stalk 1 around the steering wheel (depending on the vehicle):

A.

Slow wiping speed.

B.

Park.

C.

Intermittent wiping (depending on the vehicle)

The windscreen wiper stops for a few seconds between sweeps.

D.

Continuous slow wipe.

E.

Continuous fast wipe.

Windscreen wiper

With the ignition on, pull the stalk 1 towards you (depending on the vehicle).

A brief pull will trigger a single sweep of the wipers, in addition to the windscreen washer.

A longer pull will trigger multiple sweeps of the wipers, in addition to the windscreen washer, until the stalk 1 is released. When the stalk is released, the wipers will complete three additional sweeps followed, a few seconds later, by a fourth.

If you switch off the ignition before switching off the windscreen wiper (position B) the blade will stop on the windscreen. After switching the ignition back on, simply move the stalk 1 to position B to set the wiper blade to the park position.

warning

Before carrying out any operation in the engine compartment or on the windscreen (washing the vehicle, de-icing, cleaning the windscreen, etc.), move the stalk 1 to position B (park).

Risk of injury and/or damage.

tip

Efficiency of the wiper blades

Inspect the condition of the blades You are responsible for ensuring they are properly maintained:

  • keep them clean: clean the blades and windows regularly with water and soap;
  • do not use the wipers while the screens are dry;
  • pull them away from the screens if they have not been used for a long time.

Replace them as soon as their performance starts to be reduced: approximately after one year. Refer to the information on "Wiper blades" Wiper blades: replacement.

Precautions when using the wipers

  • In freezing or snowy weather, make sure that the wiper blades are not stuck to the screens before activating the wipers (there is risk of the motor overheating);
  • ensure that no objects are obstructing the travel of the blades.

Rear screen washer, wiper

Rear screen wiper

2_ALL_553_1_pictogramme.png

With the ignition on, turn the end of the stalk 1 to align the symbol with the mark 2.

Special feature

The rear screen is wiped once if reverse gear is selected when the windscreen wipers are in operation or have been turned off within the previous two minutes.

Rear screen washer

2_ALL_013_1_pictogramme.png

With the ignition on, turn the end of the stalk 1 to align the symbol with the mark 2.

When released, it returns to the rear screen wiper position.

tip

Before using the rear wiper, check that no object is obstructing the travel of the blade.

In frosty weather, make sure that the wiper blade is not stuck by ice (risk of motor overheating).

Inspect the condition of the blades They should be replaced as soon as they become less efficient.

Regularly clean your rear screen.

Heated rear screen

2_ALL_549_1_pictogramme.png

With the engine running, press the button 3 (the warning light appears on the instrument panel).

This function de-ices/demists the rear screen.

The function is interrupted:

  • automatically after a period defined by the system (the warning light disappears);
  • when the button is pressed again 3 (the warning light disappears).

Demisting the windscreen

Please refer to the information on "Air conditioning" on page Air conditioning: information and advice on use