Renault Kwid
Operating principle
Ultrasonic sensors, indicated by the arrows, are integrated into the bumpers to detect obstacles near the vehicle.
The function alerts the driver via sound signals that indicate the area where the obstacle was detected.
The system detects obstacles at the rear of the vehicle.
The parking assistance system is activated only when the vehicle is moving at a speed below approximately 6 mph (10 km/h).
warning
This function is an additional driving aid.
Nevertheless, under no circumstances can it replace the driver’s care or responsibility when reversing.
The driver must always be ready for sudden accidents that may occur while driving: when manoeuvring, always ensure there are no moving, small or narrow obstacles (such as children, animals, pushchairs, bicycles, stones, posts, etc.) in the blind spot.
warning
An impact on the underside of the vehicle during a manoeuvre (for example, striking a post, an elevated kerb or other street furniture) can cause damage to the vehicle (e.g. deformation of an axle).
To avoid any risk of an accident, have your vehicle inspected by an Approved Dealer.
Location of ultrasonic sensors
Ensure that the ultrasonic sensors indicated by the arrows are not blocked (by dirt, mud, snow, an incorrectly fitted or attached number plate), impacted, altered (including paint), or obstructed by any accessory fitted to the rear.
Operation
A sound signal is emitted for approximately three seconds when engaging reverse gear.
The frequency of the sound signal increases as the obstacle approaches and becomes a continuous sound at approximately 30 cm from an obstacle detected at the rear of the vehicle.
tip
In the event of a change in trajectory during a manoeuvre, the risk of collision with an obstacle may be signalled with a delay.
Note: the rear detection zone cannot be disabled.
warning
For safety reasons, make any adjustments while the vehicle is stationary.
Operating faults
When the system detects an operating fault:
- It emits a sequence of sound signals different to the standard 1 long signal;
or
- the system does not emit any sound signal or there is no visual indication when engaging reverse gear.
Check that the ultrasonic sensors are clean. If the fault persists, consult an Approved Dealer.
tip
When the vehicle is moving at less than approximately 6 mph (10 km/h), certain noises (motorcycle, lorry, pneumatic drill, etc.) may activate the Park Assist sound signals.
tip
System repairs/maintenance
- If the car is involved in a collision, the sensors may be misaligned and this could affect their operation. Consult an Approved Dealer.
- Any work to sensors, such as repairs, replacement, etc., should be carried out by a qualified professional.
Only an approved dealer is fully certified to carry out system maintenance.
System malfunctions
The system may be affected or damaged by some conditions, such as:
- adverse weather conditions (heavy rain, snow, hail, black ice, etc.);
- in case of exposure to strong electromagnetic waves (under high-voltage lines, etc.);
- some types of noise (motorcycle, lorry, pneumatic drill, etc.);
- ...
Risk of false alarms or the absence of such warnings
If the system behaves abnormally, consult an Approved Dealer.
tip
System operating limits
- To ensure that the system operates effectively, the area around the sensors must be kept clean and not modified in any way.
- Small objects moving close to the vehicle such as motorcycles, bicycles, pedestrians, etc., may not be recognised by the system.
- The system may not detect objects that are too close to the vehicle.
- The system may not provide a warning when other vehicles or objects are moving at a significantly different speed.
- When there is a change in trajectory during a manoeuvre, the system may be slow to report the obstacles.