Renault Kwid
Controls
The controls will depend on the vehicle equipment level.
- 1.
Adjusting the air temperature
- 2.
Switching air conditioning on or off (depending on the vehicle).
- 3.
Adjusting the ventilation speed
- 4.
Distribution of air.
- 5.
Switching passenger compartment isolation mode/air recirculation mode on.
Information and recommendations for use: see the paragraph on air conditioning: information and recommendations for use Air conditioning: information and advice on use.
Adjusting the air temperature
Turn the control 1 to obtain the desired temperature. The further towards the red the slide is, the higher the temperature will be.
Adjusting the ventilation speed
Turn the control 3 from 0 to 4. Turning the control to the right increases the amount of air supplied.
If you want to shut off the flow of air completely and stop the system, set the control 3 to 0 and move the control 5 to position
.
The system is deactivated: the ventilation speed for the passenger compartment air is zero (vehicle stationary). You can however still feel a slight flow of air when the vehicle is moving.
tip
Prolonged use of the air recirculation mode in position
may lead to condensation forming on the side windows and the windscreen as well as odours due to stale air in the passenger compartment.
Switching passenger compartment isolation mode/air recirculation mode on
Move the control 5 to position
.
Under these conditions, air from the passenger compartment is recirculated, with no air being taken from outside the vehicle.
Air recirculation is used to:
- isolate the passenger compartment from the external atmosphere (e.g. driving in polluted areas, etc.);
- to bring the passenger compartment to the desired temperature as quickly as possible.
Rapid demisting
- Turn the control 1 to the maximum position hot air position
- Turn the control knob 3 to position 4 for maximum air flow
- Turn the control 4 to position
. - To improve the efficiency of the demisting function, raise the control 5 to position
.
Using the climate control increases the speed of demisting.
tip
Prolonged use of the air recirculation function may lead to condensation forming on the windscreen as well as discomfort due to stale air in the passenger compartment.
It is therefore advisable to allow fresh air into the vehicle as soon as the air recirculation function is no longer required, by turning the control 5 to the right.
Distribution of air in the passenger compartment
Turn the control 4 to select the air distribution mode.
-
The air flow is directed to the dashboard vents.
-
The air flow is directed towards the dashboard vents and the footwells.
-
The air flow is directed largely towards the footwells and the dashboard vents.
Close the dashboard vents to direct all the air to the footwells.
-
The air flow is distributed between all the air vents, the front side window demisting air vents, the windscreen demisting air vents and the footwells.
-
All the air is directed to the windscreen and front side window demisting vents.
Switching air conditioning on or off
(depending on the vehicle).
The button 2 can be used to activate (warning light on) and deactivate (warning light off) the air conditioning function.
Activation is not possible if control 3 is set to 0.
Using the air conditioning system enables you to:
- lower the temperature inside the passenger compartment;
- eliminating condensation more quickly.
The air conditioning does not operate when the exterior temperature is low.
tip
Fuel consumption increases when the air conditioning is being used (switch it off when it is not required).