Renault Kwid
Label A
The tyre pressure is indicated on the label A located on the fuel tank filler flap or the driver's door (depending on the vehicle)
The tyre pressure values should be checked when the tyres are cold.
If the tyre pressures cannot be checked when the tyres are cold, assume an increase of 0.2 to 0.3 bar (or 3 PSI). Never deflate a hot tyre.
- B.
: size of the tyres fitted to the vehicle.
- C.
: tyre pressures for the front wheels (non-motorway).
- D.
: tyre pressures for the rear wheels (non-motorway).
- E.
: tyre pressures for the front wheels (motorway).
- F.
: tyre pressures for the rear wheels (motorway).
warning
Special note concerning fully loaded vehicles (maximum permissible laden weight) and vehicles towing a trailer: the maximum speed must be limited to 62 mph (100 km/h) and the tyre pressure increased by 0.2 bar.
There is a risk of explosion.
warning
For your safety and in compliance with the law: if replacement is necessary, only tyres of the same brand, size, type and profile must be used on the same axle. They must have a load capacity and speed rating equal to or greater to the original tyres, or as recommended by an approved dealer.
Failure to heed these instructions could endanger your safety and affect your vehicle's roadworthiness.
Risk of loss of control of the vehicle.
Tyre pressures
Tyre pressures must be adhered to (remember to check the emergency spare wheel at the same time). They must be checked at least once a month and always before a long journey (refer to the label stuck to the fuel filler flap or to the edge or frame of the driver's door).
Tyre pressures should be checked when cold: do not take into account high pressures that may occur due to high temperatures or after driving at high speed.
If tyre pressures cannot be checked when the tyres are cold, assume an increase of 0.2 to 0.3 bar.
Never deflate a hot tyre.
warning
Incorrect tyre pressures lead to premature tyre wear and abnormal heating of the tyres. These are factors which may seriously affect safety and lead to:
- poor road holding,
- risk of blowout or tread separation.
The tyre pressure depends on the load and speed of vehicle use. The pressures must be adjusted according to the conditions of use (refer to the label stuck to the fuel filler flap or to the edge or frame of the driver's door).
warning
A poorly tightened or missing valve cap can make the tyres less airtight and lead to pressure loss.
Always use valve caps identical to those fitted originally and tighten them fully.