New Renault Duster

-ig ma

The system displays speed limits on the instrument panel according to road signs detected on the side of the road.

It mainly uses information taken from the camera 1 attached to the windscreen behind the rear view mirror.

The sign displayed on the instrument panel changes when a road sign is detected by the system.

If the detected speed limit is exceeded, the road sign displayed on the instrument panel is modified to inform the driver.

Location of the camera 1

Make sure the windscreen is not obscured (by dirt, mud, snow, condensation etc.).

Special features

When driving in a country where speed units differ from those on your vehicle, you can manually select the speed unit shown on the instrument panel (e.g. change the unit from miles to kilometres) in order to display accurate information Displays and indicators.

Note: the system does not take into account exceptional speed limit measures, such as peak pollution days.

Operation

Warning lights

The function displays the following warning lights:

2.

Speed limit signs and additional speed limit signs (speed on exit ramp with arrow, speed with a caravan, speed limit with length of application, etc.)

3.

Additional road signs (start and end of no overtaking zone).

If the detected speed limit is exceeded, a circle flashes around the road sign (warning light 2). It remains illuminated on the instrument panel as long as the vehicle is exceeding the detected speed limit.

Temporary unavailability

If the system is unavailable for reasons related to the camera, the yellow 3_ALL_043_1_pictogramme.png symbol is displayed on the instrument panel. If there is still a problem, contact an approved dealer.

The system cannot detect the speed limit if:

  • the windscreen is not clean;
  • the camera is blinded by the sun;
  • there is insufficient visibility (fog, etc.);
  • the signs are not legible (snow, etc.) or are hidden (by another vehicle or by trees);

Note: when the front camera is obscured, the "Front camera no visibility" message appears on the instrument panel. Clean the windscreen area in front of the camera.

Operating faults

When the system detects an operating fault, the yellow 3_ALL_043_1_pictogramme.png is displayed on the instrument panel.

In some cases, they are accompanied by the following message:

  • « Driving assist unavailable » ;

or

  • « Check Front camera » ;

or

  • « Check Driving assist ». Consult an approved Dealer.

Warnings

warning

This function is an additional driving aid. This function is not under any circumstances intended to replace the due care and attention of the driver, who should at all times be in control of the vehicle.

The driver must always adapt their speed to the highway code and traffic conditions, regardless of system indications.

The system may not detect all speed limit signs or may interpret them incorrectly.

The driver must not ignore road signs undetected by the system and should give priority to complying with the actual road signs and the highway code.

In the event of poor visibility (fog, snow, frost, etc.), it is possible that the system may not indicate the correct speed to the driver.