Renault Boreal
Image of the installation
Seat not suitable for fitting a child seat.
Child seat attached using ISOFIX
Seat which allows an ISOFIX child seat to be fitted.
The rear side seats are fitted with anchorage points that allow a forward-facing car seat ISOFIX with "universal" approval to be attached. The anchorage points
are located in the boot and are visible.
warning
Ensure that the child is always secured and that the child seat or seat belt is properly fitted and adjusted Seat belts.
If necessary, adjust the seat position accordingly.
warning
Using a child restraint system which is not suitable for this vehicle will not allow you to protect the baby or child correctly. They risk serious or even fatal injury.
Installation table
The following table presents the information shown in the installation diagram to ensure that current regulations are respected.
Type of child seat | Weight of the child | Size of seat [Anchorage] | Front passenger seat | Rear seats | ||
|---|---|---|---|---|---|---|
With airbag On or Off | Side seats | Centre seat | ||||
Carrycot fitted across the vehicle Approved for group 0 | < 10 kg | L1 [F], L2 [G] | X | X | X | |
Rear-facing shell seat Approved for group 0 or 0+ | < 13 kg | R1 [E] | X | IL (1) | X | |
Rear-facing seat Approved for group 0+ or 1 | < to 13 kg and 9 to 18 kg | R2 [D], R2X [D] | X | IL (1) | X | |
R3 [C] | X | X | X | |||
Forward-facing seat Approved for group 1 | 9 kg to 18 kg | F3 [A], F2 [B], F2X [B1] | X | IUF-IL(1) (2) | X | |
Booster seat Approved for group 2 or 3 | 15 kg to 25 kg and 22 kg to 36 kg | B2 | X | IUF-IL(1) (2) | X | |
| B3 | X | X | X | |||
Seati-Size | Rear-facing seat | X | i-U(1) | X | ||
Forward-facing seat | X | i-UF(1) (2) | X | |||
Booster seat | X | i-UF(1) (2) | X | |||
Refer to the brochure “Child safety equipment”, available from an Authorized Dealer, to choose the seat suited to your child and recommended for your vehicle.
X = Seat not suitable for fitting a child seat.
IUF = Seat that allows the installation of forward-facing child seats with "universal" approval using ISOFIX attachments; check that it can be fitted correctly.
IL = Seat that allows approved "semi-universal" or "vehicle-specific" child seats to be fitted using the ISOFIX attachments; check that it can be fitted correctly.
i-U = Only suitable for forward- and rear-facing i-Size "universal" child seats: check that it can be installed.
i-UF Suitable for forward- and rear-facing i-Size "universal" child seats: check that it can be installed.
(1) To install the rear-facing child seat, move the front seat as far forward as it will go then move it back as far as possible, without allowing it to touch the child seat.
(2) Always retract the headrest of the seat on which the child seat is mounted. This action must be carried out before installing the car seat Rear headrests. Move the seat in front of the child forwards, move the seatback forward to avoid contact between the seat and the child's legs.
The size of the ISOFIX child seat is indicated by a letter:
- F3 [A], F2 [B],F2X[B1]: for Group 1 (9 kg to 18 kg) forward-facing child seats;
- R2 [D], R2X [D], R3 [C]: rear-facing seats or bucket seats in Group 0+ (less than 13 kg) or Group 1 (9 kg to 18 kg);
- R1 [E] rear-facing bucket seats in Group 0 (less than 10 kg) or group 0+ (less than 13 kg);
- L1[F], L2 [G]: baby carriers in Group 0 (less than 10 kg);
- B2, B3: for booster seats in Groups 2 and 3 (15 kg to 25 kg and 22 kg to 36 kg).