Rear headrests

Standard chassis version

(5-seater)
To raise it
Slide it to the required height.
To lower it
Pull it towards you and slide it to the required height.
To remove the headrest
Raise the headrest then press the tabs 1 to release it.
To replace it
Press the tab 1 and insert the rods into the holes with the notches facing forwards.
Storage position 2
Pull it towards you and lower it completely.
When the headrest is set at the lowest position, this is for storage only: it should not be in this position when the seat is occupied.
WARNING
The headrest is a safety component; check that it is fitted and in the correct position.

Long chassis version

(5-seater or 7-seater)
Position for use
Lift the headrest fully until it locks. Check that it is correctly locked.
To remove the headrest
Raise the headrest as far as it will go, then press button 3 or 4 and remove the headrest.
To replace it
Fit the rods into their housing and push down the headrest until it locks to set it to raised position.
Check that it is correctly locked.
Storage position 5 or 6
Press button 7 or 8 and lower the headrest completely.
When the headrest is set at the lowest position, this is for storage only: it should not be in this position when the seat is occupied.