New Renault Duster

bis Heute

Settings

To move the seat forwards or back

Lift and hold the lever 1 to unlock the seat. When the seat is in the required position, release the lever and ensure that the seat is locked in place.

To raise or lower the seat base

(depending on the vehicle)

Raise or lower the handle 2 as many times as necessary until the desired position is reached.

To tilt the seatback

Lift handle 3 and tilt the seatback to the desired position. Release the handle at the desired position and make sure that it is locked.

Lumbar adjustment

(depending on the vehicle)

Rotate the knob 4 to increase or decrease the support.

warning

After making adjustments, make sure that the seatbacks are correctly locked in place.

warning

For safety reasons, carry out any adjustments while the vehicle is stationary.

We would advise you not to recline the seatbacks too far to ensure that the effectiveness of the seat belts is not reduced.

Make sure that the seatbacks are correctly locked in place.

Nothing should be placed on the floor (area in front of the driver) as these objects may slide under the pedals during sudden braking manoeuvres, thus obstructing their use.

Front seats with electric controls

(Depending on the vehicle)

Backrest adjustment

To tilt the backrest, flip the top of the switch 5 forward or backward.

Seat adjustment

To move the seat forward or backward, move the switch 6 forward or backward. To raise or lower the seat cushion, move the back of switch 6 up or down.

warning

For safety reasons, carry out adjustments while the vehicle is stationary.

We would advise you not to recline the seatbacks too far to ensure that the effectiveness of the seat belts is not reduced.

Make sure that the seatbacks are correctly locked in place.

There should be no objects on the floor (area in front of the driver), as these can slide under the pedals during sudden braking manoeuvres, which may obstruct use.

Central armrest 7

(depending on the vehicle)

To adjust the position of the armrest, slide it forwards or backwards until it reaches the stop.

Ventilated seats

Ventilation seats work on the principle of absorbing and exporting the air in the passenger compartment without using the vehicle’s air conditioning. For the best performance, you are advised to use this function with air conditioning switched on.

With the ignition on:

  • pressing the switch 8 on the required seat for the first time activates the ventilation system at maximum power. All the integrated switch warning lights come on;
  • a second press decreases the ventilation to medium power. One integrated warning light comes turns off;
  • a third press decreases the ventilation to low power. One integrated warning light turns off;
  • a fourth press switches off ventilation.

NOTE: If you switch off the engine and restart it, the ventilation function will be off.

tip

Do not use ventilation with ignition off, because it will drain the battery power.

  • when HIGH power mode is on condition, it shall be changed from HIGH to MEDIUM mode automatically after approximately 20 minutes of continuous usage.

  • the ventilated function will be turned off automatically approximately 2 hours of continuous usage.