This vehicle has an electronic START/STOP button 1, which can be pressed to start and stop the vehicle. The vehicle must detect the key to activate the system.

■ Accessory functions

You can use button 1 to switch between different power modes:

  • Mode 0: Unlocks the vehicle and opens the driver's door. In this mode, electrical functions such as the clock, audio, and side lights can be used for a limited time.
  • Mode I: When button 1 is set to mode 0, pressing button 1 once without pressing the brake pedal will switch the button to mode I, and pressing button 1 again will restore mode 0. Some quick functions such as power windows can be used in this mode.
  • Mode II: When the START/STOP button is set to mode 0 or I, pressing and holding the START/STOP button for a few seconds without pressing the brake pedal will switch the START/STOP button to mode II. In this mode, most electrical devices such as the headlamps can be used. The system will complete a self-test in a few seconds.
warning

Mode I, especially mode II, drains the battery power quickly and may not start the vehicle due to battery discharge when used for a long time.

Avoid unnecessary use and immediately start the vehicle to charge when the 12V battery charge warning light appears on the instrument panel.

warning

Driver's responsibility when parking or stopping the vehicle

Never leave an animal, child or adult who is not self-sufficient alone in your vehicle, even for a short time.

They may pose a risk to themselves or to others by starting the engine, activating equipment such as the electric windows or locking the doors.

Also, in hot and/or sunny weather, please remember that the temperature inside the passenger compartment increases very quickly.

RISK OF DEATH OR SERIOUS INJURY.

Be careful because the engine may start if you step on the pedal and press the START/STOP button while in the key detection area, even if the key is outside the vehicle.

■ Ignitionstarter switch on a vehicle with key

  • With a valid key in your possession,
  • with the gear lever in the P position,
  • depress the brake pedal,
  • and press the START/STOP button 1.

For hybrid vehicles, on the instrument panel The indicator light turns on to indicate that the vehicle is ready to drive.

warning

If the driver's seat belt is not fastened, the parking brake will not be released.

■ When the engine does not start

If the vehicle is in an area with heavy signal interference, the key battery is low, or the START/STOP button system is broken, a message indicating that the key is not in the vehicle may be displayed on the instrument panel when the START/STOP button is pressed. In this case, the engine cannot be started using the START/STOP button system.

You can start the vehicle by following these steps:

  • Put the gear lever in P.
  • Place the key in the cup holder with the key signal detection indicator on the center console.
  • Press the brake pedal.
  • Press the START/STOP button.

If the vehicle is experiencing strong signal interference, use the backup start program to move the vehicle away from the area to restore the starting function.

If the START/STOP button system still does not work after replacing the key battery and moving the vehicle away from the interference area, contact an authorized service center as soon as possible.

Precautions when starting the vehicle

  • In extremely cold weather or when the vehicle has not been driven for a long period of time, do not press the accelerator pedal after the vehicle is started and wait until the engine warms up.
  • In winter, the initial idle RPM may be high due to low temperatures.
  • Engine noise may occur until the engine reaches normal operating temperature.

■ Conditions for stopping the engine

  • Put the gear lever in P while the vehicle is stopped.
  • With the key inside the vehicle, press the START/STOP button 1 to stop the engine.

Note: If the driver's door is opened while the vehicle is turned off and in power mode I or II, a message may appear on the instrument panel and an alarm may sound.

warning

When you leave your vehicle, especially if you have your key with you, check that the engine is completely switched off.

warning

Never switch off the ignition before the vehicle has come to a complete stop.

Once the engine has stopped, the brake servo, power-assisted steering etc., and the passive safety devices such as the airbags and pretensioners will no longer operate.

warning

Do not park the vehicle or run the engine in locations where combustible substances or materials such as grass or leaves can come into contact with the hot exhaust system.

■ Remote engine start

This function is used when you need to start the vehicle remotely.

If the vehicle is in theft prevention mode and the key is within the detection range, press the lock button 2 on the key, then press and hold the remote start button 3 within 2 seconds. The turn signal will flash three times and the engine will start.

If you open the door in the remote start mode, get in the vehicle, press the brake pedal, and press the vehicle start button again, it will change to normal driving mode and you can drive.

If the vehicle is in the remote start mode and the key is within the detection range, pressing the remote start button 3 on the key twice will end the remote start function. When the remote start function ends, the turn signal will flash once briefly and then once long.

The remote start function may not work smoothly in the following situations.

  • If the brake pedal is pressed
  • If the coolant level is low
  • If the doors are open, including the engine bonnet
  • If there is a problem with the engine
  • If the engine is already running
  • If the fuel level is low (less than 8 L)
  • If the gear lever is not in P
  • If the vehicle is not locked
  • If a software update is in progress
  • If two or more consecutive remote start attempts are made without driving
  • If the battery voltage is low
warning

When using the remote start feature, make sure power-consuming devices (wipers, lamps, radio, seat heaters, steering wheel heaters, etc.) are turned off and all accessories are disconnected before leaving the vehicle. There is a risk of fire.

warning

Do not use the remote start function in the following cases:

  • If the vehicle is in a garage or confined space, there is a risk of poisoning or suffocation due to exhaust fumes.
  • If the vehicle is covered with a protective cover, there is a risk of fire.
  • If the engine bonnet is open, there is a risk of burns or serious injury.

Depending on the ordinances of each local government, fines may be imposed for exceeding the idling time limit. Before using the function, please refer to the ordinances of each local government and be careful when using it.