Five-seater version

² Seat not suitable for fitting child seats.

Child seats attached using ISOFIX mounting

ü Seat which allows an ISOFIX child seat to be fitted.

± The rear seats are fitted with an anchorage point which allows a forward-facing ISOFIX child seat with universal approval to be attached. The anchorage points are located in the luggage compartment and are visible.

The size of the ISOFIX child seat is indicated by a letter:

- A, B and B1 [F3, F2, F2X]: for forward-facing seats in group 1 (9 to 18 kg);

- C [R3]: for rear-facing seats in group 1 (9 to 18 kg);

- D and E [R2, R1]: shell seats or rear-facing seats in group 0 or 0+ (less than 13 kg);

- F and G [L1, L2]: for carrycots in group 0 (under 10 kg).

Using a child safety system which is not approved for this vehicle will not correctly protect the baby or child. They risk serious or even fatal injury.

The five-seater version complies with the local regulations in the country where the vehicle is sold.

The table below summarises the information already shown on the diagram on the next page, to ensure the regulations in force are respected.

Five-seater version

Type of child seat

Weight of the child

Seat size ISOFIX

[Height]

Front passenger seat

Rear side seats

Rear centre seat

Carrycot fitted across the vehicle

Group 0

< 10 kg

F, G

[L1, L2]

X

IL (1)

X

Rear-facing shell seat

Group 0 or 0+

< 13 kg

E

[R1]

X

IL (2)

X

Forward facing seat/shell seat

Group 0+ and 1

< to 13 kg and 9 to 18 kg

C, D

[R3, R2]

X

IL (2)

X

Forward-facing seat

Group 1

9 to 18 kg

A, B,B1

[F3, F2, F2X]

X

IUF - IL (3)

X

Booster seat

Group 2 and 3

15 to 25 kg and 22 to 36 kg

X

IUF - IL (3)

X

I-Size seats

X

X

X

X = Seat not suitable for fitting child seats of this type.

IUF/IL = On equipped vehicles, seat which allows a child seat with "Universal/Semi-universal or vehicle-specific" approval to be fitted using the ISOFIX system; check that it can be fitted.

(1) A carrycot is fitted crosswise and occupies at least two seats (the child’s feet are placed nearest the door).

(2) If necessary, position the vehicle seat as far back as possible. In order to install a rear-facing child seat, move the front seat as far forward as possible, then move the front seat back as far as it will go, without allowing it to come into contact with the child seat.

(3) In all situations, remove the headrest from the rear seat on which the child seat is fitted. This must be done before fitting the child seat. Please refer to the information on the “Rear headrests” in Section 3. Move the seat in front of the child forwards, move the seatback forward to avoid contact between the seat and the child’s legs.

The size of the ISOFIX child seat is indicated by a letter:

- A, B and B1 [F3, F2, F2X]: for forward-facing seats in group 1 (9 to 18 kg);

- C and D [R3, R2]: rear-facing seats or shell seats in group 0+ (less than 13 kg) or group 1 (9 to 18 kg);

- E [R1]: rear-facing shell seats in group 0 (less than 10 kg) or 0+ (less than 13 kg);

- F and G [L1, L2]: for carrycots in group 0 (under 10 kg).