Display Link - Navi Link

"Warnings"

This item allows you to set up warnings.

Warning in the event of excess speed

Maps may contain information about the speed limits of the road segments. The system is able to warn you if you exceed the current limit.

This information may not be available for your region, or may not be fully correct for all roads on the map.

The following warning types are available:

• Beep: you receive a non-verbal warning when you exceed the speed limit;
• Visual warning: the current speed limit is displayed and flashes in red on the map when you exceed it.

Press "On" or "Off" to activate or deactivate the warning.

Speed limit always visible

Activate or deactivate the speed limit display for the section of road taken by pressing "On" or "Off".

Alert point warnings

When the driver crosses the increased care area, a visual warning signal appears on the screen, along with a beep. These hazardous areas are sections of road on which drivers should take extra care. They can be permanent or temporary. You can activate or deactivate this function.

Pre-alert distance

You can choose a distance from a number of choices, to give the distance at which you wish to be notified of a hazardous area.

"Configuring a route"

This function allows you to set how routes will be calculated.

« Route calculation »

This system offers three criteria for calculating a route:

• "Fast": gives a quick route if you can travel at or near the speed limit on all roads;
• "Short": gives a short route to minimise the distance to travel;

• "Eco": this mode produces a compromise between fast and short routing modes. If you can save a certain distance by travelling for slightly longer time in exchange, it will do just that. The resulting route might be shorter than the fast variant, but not significantly slower.

"Motorways"

You might need to avoid motorways when you are driving a slow car or you are towing another vehicle.

"Toll roads"

You can authorise or refuse authorisation for roads requiring the purchase of special authorisation for a certain period.

"Toll roads"

You can authorise or refuse authorisation for the use of toll roads.

"Ferries"

You can authorise or refuse authorisation for all types of ferries, boats and trains.

"Carpooling"

This function enables you to view roads only intended for two drivers sharing.

"Off-road tracks"

You can authorise or refuse authorisation for the use of off-road tracks.

"Map Settings"

Refer to the information in the section on "Map settings".

"Language Setting"

This function allows you to change the language of voice guidance. Please refer to the section on "Guidance" in this manual.

"Data format"

This function allows you to change the format of coordinate.

This system offers three types of format.

GPS

This function allows you to check the status of GPS satellites.

Press "GPS" to see the GPS information (screen A).

"Map update "

This function enables you to check the dates of your last updates.

"Traffic"

This function enables you to activate or deactivate "Traffic service", the flagging of different events and to manage alternative routes in the event of accidents or traffic jams.

« Traffic service »

You an activate or deactivate warnings for different incidents occurring along your route.

"Detour"

This function allows you to save time when an incident occurs on your trip, by offering you an alternative route.

The multimedia system will offer you to choose a time after which a new route is suggested to you with a detour to save time.

"Event types"

This function enables you to choose the types of events to be displayed during navigation:

• "All events";
• "Traffic incidents";
• "Roads closed or blocked";
• "Accident";
• ...