Renault Kardian
Modular roof bars
If the vehicle is equipped, this device enables you to position the roof bars in either longitudinal or transverse position.
To place the bars in the transverse position:
- unclip the rotary covers 1 and put them in the vertical position (movement A);
- loosen the bolts 2 using the torque wrench 7 located in the glovebox;
- raise bars 3 and 4 and fit them in transverse position 5. To do this, place the bar 3 (movement B) in the front position, then place the bar 4 (movement C) in the rear position.
Note: Make sure that bars 3 and 4 are correctly positioned according to the direction shown on each mark 6 located on the mountings at each end of the bars.
tip
Maximum permissible load on roof rack Weights (in kg).
- use the tool 7 to tighten the bolts 2: markers D and E located on the tool are offset (mark 8);
- tighten the bolts 2 as far as possible using the tool 7 until markers D and E located on the tool 7 are parallel (mark 9);
- re-clip the rotary covers 1.
Note: bars 3 and 4 are not interchangeable.
tip
It is strictly forbidden to place the roof bars in the transverse position (carrying position) when entering a roller-type car wash.
warning
Make sure that the two modular roof bars are correctly position and locked.
tip
Roof bars in the transverse position
The maximum speed must be limited to 80 mph (130 km/h).
tip
When not using the bars in transverse position, refit the bars in longitudinal position in order to optimise fuel consumption and avoid air noise.
tip
If lost, contact an approved dealer to obtain the bolts 2 and the tool 7.
warning
The modular roof bars are originally assembled and approved by our Technical Department.
They are provided together with the bolts 2 and the tool 7. These must only be used for attaching the roof bars to the vehicle.
warning
Check that the objects and/or accessories (bicycle rack, roof box, etc.) fitted to the modular roof bars are correctly positioned, evenly distributed and secured.
Longitudinal roof bars
If fitted on the vehicle, you can transport luggage or additional equipment (bicycle rack, ski rack, etc):
- on a roof rack;
- on transverse roof bars fitted onto the longitudinal roof bars 10;
- directly onto the longitudinal roof bars.
It is forbidden to fit longitudinal roof bars on vehicles which are not originally equipped with them.
tip
For information on the range of equipment adapted to your vehicle, we advise you to consult an approved Dealer. Refer to the manufacturer’s instructions for information on how to fit and operate the equipment.
Please keep these instructions with the rest of the vehicle documentation.
Maximum permissible load on roof rack Weights (in kg).
User precautions
Handling the tailgate
Before operating the luggage compartment door, check the objects and/or accessories (bicycle rack, roof box, etc.) fitted on the roof bars: these must be correctly positioned and secured, and must not prevent the luggage compartment door from operating correctly.
warning
The attaching of any carrying device (bike rack, luggage box, etc.) resting on the luggage compartment lid is prohibited. To install a carrying device on your vehicle, contact an approved dealer.