Display Link - Navi Link

When fitted, this function can be used to program the engine to start remotely in order to heat or ventilate the passenger compartment up to 24 hours before the vehicle is used.

Adjust the heating level required (temperature, de-icing) before programming the function. Configuration and programming are done via the multimedia display.

Setting the start time for the function

  • Switch on the ignition, then press 1 from the main menu. The A screen is displayed;

  • select the "ON" button on the "Auto start." line to activate the function;
  • set the start time for when you wish to start to use your vehicle by pressing line 2;
  • press on the "up" and "down" arrows to scroll through the hours and minutes until you get the desired time;
  • press "OK" to confirm. The 4 marker shows you the time left before the time you wished to use the vehicle;
  • press "OK3" to confirm and finalise the programming;

  • set the air conditioning controls in the passenger compartment to the desired temperature when starting up the engine, then enable de-icing mode;
  • turn off the ignition.
tip

To activate a programmed remote start-up, you must select a time at least 15 minutes later than the time displayed by the multimedia system.

When locking your vehicle, two flashes will appear then the hazard warning lights and indicator lights switch on for approximately three seconds to indicate that the programming has been taken into account.

The remote engine start-up operates if:

  • the lever is in neutral (on vehicles with a manual or sequential gearbox);
  • the lever is in position P for vehicles with an automatic gearbox;

  • the ignition is switched off;
  • all the opening elements (bonnet, doors, boot) are closed and locked when you leave the vehicle.

Note: you must switch off your multimedia system by pressing the "OFF" button before leaving your vehicle in order for the remote engine start-up function to work.

"Activate every 2 hours"

This function enables your vehicle to start automatically every two hours depending on the engine temperature.

To activate this function, press the "ON5" button.

When this function is activated, the ventilation system will not activate during the first four start-ups, if they occur.

In very cold conditions, the vehicle will start automatically and will stay on for approximately ten minutes before switching off.

If the engine temperature does not require a restart, the vehicle will not start automatically during the first four reactivation times and will return to standby for two hours. The engine will be restarted if the engine temperature is too low.

In all cases, the last start-up will happen.

Approximately fifteen minutes before the programmed time, the engine starts and remains on for about ten minutes.

Note: the mark 6 reminds you of the vehicle start time that you have already set.

tip

Depending on the vehicle, please ensure that consumers such as the wipers, exterior lights, radio, heated seats, heated steering wheel, etc. are disabled and that all accessories are disconnected before leaving the vehicle.

tip

Special note for vehicles fitted with the "Activate every 2 hours" function.

It is imperative that the vehicle is driven for at least 10 minutes between each use of the function. Risk of engine oil wear.

warning

Do not park the vehicle or run the engine in locations where combustible substances or materials such as grass or leaves can come into contact with the hot exhaust system.

warning

Driver's responsibility when parking or stopping the vehicle

Never leave an animal, child or adult who is not self-sufficient alone in your vehicle, even for a short time. They may put themselves or others at risk, for example by starting the engine, switching on equipment such as the electric windows or by locking the doors etc. Also, in hot and/or sunny weather, please remember that the temperature inside the passenger compartment increases very quickly.

RISK OF DEATH OR SERIOUS INJURY.

tip

In extreme conditions, the remote start-up by programming may not work.

warning

Do not use or programme the remote engine start-up function when:

  • the vehicle is in a garage or in a confined space.

Risk of poisoning or suffocation by exhaust gas emissions.

  • the vehicle is covered with a protective cover.

Fire hazard.

  • the bonnet is open or before it opens.

Risk of burns or serious injury.

Depending on the country, the use of the remote starting function or its programming can be prohibited by the legislation and/or the regulations in force.

Before using this function, check the legislation and/or the regulations for the country in force.