Renault Kardian Latam
Attachment using the ISOFIX system
Image of the installation
Seat not suitable for fitting child seats.
Child seat attached with the system ISOFIX
Seat that allows a child seat ISOFIX or i-Size to be fitted.
The rear side seats are fitted with anchorage points that allow a forward-facing ISOFIX car seat with "Universal" approval to be attached. The anchorage points
are located in the boot and are visible.
warning
Ensure that children remain secured and that the child seat or seat belt is properly set and adjusted.
If necessary, adjust the seat position accordingly.
warning
Using a child safety system that is not approved for this vehicle will not give proper protection for your baby or child. They risk serious or even fatal injury.
Installation table
The table below summarises the information already shown in the diagram on the next page, to ensure the regulations in force are respected.
Type of child seat | Weight of the child | Size of seat [Anchorage] | Front passenger seat | Rear seats | |
|---|---|---|---|---|---|
Side seats | Centre seat | ||||
Carrycot fitted across the vehicle Group 0 | < 10 kg | F , G [L1, L2] | X | X | X |
Rear-facing frame Group 0 or 0+ | < 13 kg | E [R1] | X | IL (1) | X |
Rear-facing seat Group 0+ or 1 | < 13 kg and 9 to 18 kg | D [R2, R2X] | X | IL (1) | X |
C [R3] | X | X | X | ||
Forward-facing seat Group 1 | 9 to 18 kg | A, B, B1 [F3, F2, F2X] | X | IUF-IL (1) (2) | X |
Booster seat Group 2 or 3 | 15 to 25 kg and 22 to 36 kg | [B2] | X | IUF-IL (1) (2) | X |
| i-Size | X | i-U | X | ||
Refer to the "Child safety equipment" booklet, available from an approved dealer, to select the most suitable seat for your child and recommended for your vehicle.
X = Seat not suitable for fitting a child seat.
IUF = Seat that allows the installation of forward-facing child seats with "Universal" approval using ISOFIX attachments; check that it can be fitted correctly.
IL = Seat that allows approved "Semi-universal" or "Vehicle specific" child seats to be fitted using the ISOFIX attachments; check that it can be fitted correctly.
i-U = Suitable for forward- and rear-facing "universal" child
(1) To install the rear-facing child seat, move the front seat as far forward as it will go then move it back as far as possible, without allowing it to touch the child seat.
(2) In all situations, remove the rear headrest of the seat on which the child seat is positioned. This must be done before fitting the child seat. Move the seat in front of the child forwards, move the seatback forward to avoid contact between the seat and the child's legs.
The size of the ISOFIX child seat is indicated by a letter:
- A, B and B1 [F3, F2, F2X]: for Group 1 (9 kg to 18 kg) forward-facing child seats;
- CandD [R3, R2, R2X]: rear-facing or bucket seats in Group 0+ (less than 13 kg) or Group 1 (9 to 18 kg);
- E [R1]: rear-facing bucket seats in group 0 (less than 10 kg) or 0+ (less than 13 kg);
- F and G [L1, L2: for carrycots in group 0 (less than 10 kg);
- [B2]: for booster seats in groups 2 and 3 (15 kg to 25 kg and 22 kg to 36 kg).